How to choose nitrile-coated cut-resistant gloves: level and size

A cut-resistant glove with a nitrile palm is for when you handle sheet metal, glass, metal components or materials with sharp edges, and at the same time need a secure grip even on oily parts. The yarn on the back of the hand protects against cuts, the nitrile coating on the palm holds the part. Choose the protection level shown on the glove according to the risk of the task, and the size (here from 6 to 11) so that it fits snugly without losing sensitivity.

The types

The collection has a single type of glove, the nitrile-coated cut-resistant glove, in four series:

• Kyorene 02-205R and 02-405R. Work gloves with a nitrile-coated palm, in grey and black or blue and black. You will find them as 02-205R and 02-405R.
• Kyorene Pro K01-424. Another series of the same type, the K01-424.
• Hyflex 11-561. The 11-561 completes the collection.

The differences in cut level, thickness and coating are on the data sheet for each model: compare them before ordering.

How to choose by job

• Mechanical workshop and work with oil. The nitrile palm is designed for gripping oily parts: this is the typical case for this collection.
• Handling sheet metal and profiles. Look for a high cut level and check that the cuff does not leave the wrist exposed.
• Fitting and assembly. If you need to feel screws and small components, choose the snuggest size and the thinnest glove.
• Warehouse and logistics. Opening boxes with a cutter and handling strapping calls for cut protection, but not a glove that is too thick.
• Near rotating parts. Do not use these gloves: they can be pulled in.

In practice the trade-off is always the same: more protection usually means less sensitivity. Start from the real risk of your task and choose the lowest level that genuinely covers it.

The features to look at

• Cut protection level. It is shown on the glove next to the pictogram of the EN 388 standard, covering mechanical risks. The higher the level, the better it resists cuts, but it often becomes less sensitive. Choose the right one for the real risk.
• Size. Here from 6 to 11. A glove that is too big slips and loses grip; one that is too tight tires the hand.
• Colour. Grey and black or blue and black: it helps tell gloves apart by department or by task, and black hides dirt better.
• Coating. Nitrile grips well on oil. When the coating peels off or wears away, the glove must be replaced.

Common mistakes

• Thinking that cut-resistant means knife-proof. No glove stops a blade driven in with force.
• Choosing the wrong size because a big glove seems more comfortable.
• Using it with dirty or wet hands, which ruin the grip and the yarn.
• Carrying on using it with cuts or a peeling coating.
• Using it near rotating bits and chucks.

Frequently asked questions

Can I use it for work with oil?

Yes, the nitrile palm is suited to gripping oily parts. If the glove becomes completely saturated or wears out, it must be replaced.

What does the number on the glove mean?

With the EN 388 standard it indicates performance against mechanical risks, including cuts. The cut level is the one that matters for this collection.

How many models are there and in what sizes?

Four models, in sizes 6 to 11.

How do I choose the size?

Try them on the hand you use most: they should fit the fingers without creases and without tightening the wrist.

Can they be washed?

Follow the manufacturer's instructions on the label. In any case, if the coating is damaged after washing, the glove must no longer be used.

You will find the models in the Nitrile-Coated Cut-Resistant Gloves collection: to choose the right level for your task, ask the AMES technicians for advice or a quote.