Centring guide pin SPIT

What it is

Centring guide pin SPIT. Key specifications: type SDD centring point, length (mm) 200, compatibility SD160 core drill.

The centring bit is a bit or pilot that fits in the centre of the core bit and is used to drill the first hole and to position the core bit on the marked point.

What it is for

Used for core drilling concrete and masonry, for service openings and sampling and for drilling reinforced concrete, in hammer or rotary hammer mode.

How to use it

Fit it in the centre of the core bit before starting, rest it on the point and start at low speed to make the pilot hole. Remove it once the core bit has cut its groove, if so intended, and replace it when worn.

Where it is used

• Demolition
• Building services
• Renovation

Technical data

• Type: SDD centring point
• Length (mm): 200
• Compatibility: SD160 core drill
• Pack (pcs): 1

Who it is for

Designed for demolition operatives, electricians and plumbers.

Related products

• Extension SDD SPIT
• SDD extension for core bits SPIT 200260
• Diamond core drill case Sd160 Trix160 SPIT — from the category Electric Core Drills
• Site vacuum cleaner Ac1630pm SPIT — from the category Single-Phase Industrial Wet and Dry Vacuums
• STS stone splitter for slabs and interlocking pavers Probst — from the category Construction Machines for Cutting, Core Drilling and Compaction
• Browse the whole category: Core Drilling Equipment

Before you order

In your request, please state the length and the quantities required, so we can give you the right quotation first time.

For prices and availability, request a quote from AMES Srl: we will reply with our quotation, delivery times and, where needed, an equivalent technical alternative.