Pump out and transfer dirty water containing light sludge, suspended solids and wastewater.

NBR gaskets for PE tanks, Rototec
Also known as: seals
Key features
- MaterialNBR rubber
- ModelGG50, GG63, GG80, GG100, GG110, GG125, GG125S15, GG160, GG200, GG250, GG315
- Installationhole made with a hole saw, gasket insertion and pass-through pipe stub
- UseSealing for through-wall fittings on polyethylene tanks and vessels
What it is
Gaskets are NBR rubber components intended for installers and designers. They are used to install bulkhead fittings on polyethylene tanks and vats, drilling with a hole saw and ensuring the correct seal at the penetration. The procedure is as follows: drill with a hole saw of slightly larger diameter than the fitting, insert the gasket and pass the pipe through, consulting the diameter / hole saw Ø table. The gaskets are designed to ensure a seal at inlet/outlet penetrations on polyethylene products, installed using a hole saw according to the diameter indicated. Maintenance consists of periodic seal checks and replacement in the event of wear.
These are accessories and spare parts for buried tanks and basins: extension shafts to bring the opening up to ground level, inspection covers, gaskets and branch fittings for the connections.
What it is for
Used for filtering system water and in the installation and maintenance of plumbing systems.
How to use it
Choose parts compatible with the tank and fit them watertight, with the gasket intact and clean in its seat. The extension shaft brings the cover up to ground level. Keep the cover closed at all times to prevent falls and infiltration, and open it only for inspections.
Where it is used
- Building services
- Water engineering works
Technical data
- Material: NBR rubber
- Model: GG50, GG63, GG80, GG100, GG110, GG125, GG125S15, GG160, GG200, GG250, GG315
- Installation: hole made with a hole saw, gasket insertion and pass-through pipe stub
- Use: Sealing for through-wall fittings on polyethylene tanks and vessels
Who it is for
Designed for plumbers.
Related products
- Low-load activated-sludge system Rototec
- NBR lid gasket, Rototec
- Round inspection chamber with tap — from the category Inspection Chambers
- Submersible pump for heavily soiled water JV Wortex — from the category Submersible Wastewater Pumps
- Portable socket outlet board Friggeri PC-DN0300 — from the category Distribution Boards and Protection Devices
- Browse the whole category: Water Purification
Before you order
Tell us the quantities you need and the intended use: if there is a more suitable version, or an equivalent available sooner, we will let you know.
For prices and availability, request a quote from AMES Srl: we will reply with our quotation, delivery times and, where needed, an equivalent technical alternative.
Specifications 4
| Material | NBR rubber |
|---|---|
| Model | GG50, GG63, GG80, GG100, GG110, GG125, GG125S15, GG160, GG200, GG250, GG315 |
| Installation | hole made with a hole saw, gasket insertion and pass-through pipe stub |
| Use | Sealing for through-wall fittings on polyethylene tanks and vessels |
The perfect setup for this job
Everything you need in one place, from functionality to safety.
For the job
Pump out muddy water with sand and debris from excavations, sumps and flooded rooms.
Eliminate or mask bad odours from portable toilets, waste, drains and rooms.
Distribute power on site and protect people and tools from overloads and earth leakage.
For safety
Protect hands from cuts, impacts, heat, cold and chemicals.





