Skip to content
0 Quotes 0Compare
All Pedrollo products

Electric pump Fluid Solar Pedrollo

Code FLUID

Key features

  • CapacityUp to 180 l/min (10.8 m³/h)
  • Motor2-pole
  • Outer casingStainless steel AISI 304
  • SupportTechnopolymer and brass
  • HeadUp to 194.5 m
  • Maximum operating depth (m)100
See all 13 specifications

What it is

Electric pump Fluid Solar Pedrollo. Key specifications: capacity Up to 180 l/min (10.8 m³/h), motor 2-pole, outer casing Stainless steel AISI 304.

A clean water pump is a surface or submersible electric pump that lifts or pressurises clear water from wells, cisterns and tanks.

What it is for

Used in irrigation systems, from the water supply point to the emitter and for pumping water out of excavations, tanks and sumps.

How to use it

Install surface pumps on a level base close to the draw-off point, with a foot valve on the suction pipe, and fill them with water before first start-up; lower submersible pumps suspended on a rope. Use them only with clean, sand-free water and never let them run dry. Connect them to a circuit protected by an RCD and, in winter, drain outdoor pumps to protect them from frost.

Where it is used

  • Agriculture
  • Renewable energy (solar PV)
  • Water engineering works

Technical data

  • Capacity: Up to 180 l/min (10.8 m³/h)
  • Motor: 2-pole
  • Outer casing: Stainless steel AISI 304
  • Support: Technopolymer and brass
  • Head: Up to 194.5 m
  • Maximum operating depth (m): 100
  • Liquid temperature: Up to +35 °C
  • Maximum sand content: 200 g/m³
  • IP protection rating: IP68
  • Discharge body: Stainless steel AISI 304
  • Impeller: Derlin®
  • Diffuser: Noryl™
  • Shaft: Stainless steel AISI 304

Who it is for

Designed for plumbers, solar PV installers and agricultural workers.

Related products

Before you order

In your request, please state the rated load or flow rate and the quantities required, so we can give you the right quotation first time.

For prices and availability, request a quote from AMES Srl: we will reply with our quotation, delivery times and, where needed, an equivalent technical alternative.

Quantity
Specifications 13
CapacityUp to 180 l/min (10.8 m³/h)
Motor2-pole
Outer casingStainless steel AISI 304
SupportTechnopolymer and brass
HeadUp to 194.5 m
Maximum operating depth (m)100
Liquid temperatureUp to +35 °C
Maximum sand content200 g/m³
IP protection ratingIP68
Discharge bodyStainless steel AISI 304
ImpellerDerlin®
DiffuserNoryl™
ShaftStainless steel AISI 304

The perfect setup for this job

Everything you need in one place, from functionality to safety.

For the job